Grizzly Automobile Parts G8721 G8722 User Manual

MODEL  
G8721/G8722  
ENGINE STANDS  
INSTRUCTION SHEET  
Specifications  
Model: G8721 Engine Stand  
Maximum Load: 1,000 lbs.  
To reduce the risk of property damage,  
serious personal injury, or death when  
using this engine stand, take the following  
precautions:  
Size: (L x W x H): 36" x 2912" x 3412".  
Model: G8722 Engine Stand  
Maximum Load: 1,250 lbs.  
Size: (L x W x H): 42" x 33"x 3412".  
Refer to your vehicle service manual to  
locate the safe engine lifting/support  
locations, and to verify that the engine  
weight does not exceed the maximum  
engine stand load rating.  
Model G8721 Assembly  
Note: Refer to Figure 2 for reference.  
Never attempt to start or run an engine  
on this engine stand.  
Only use this engine stand on a hard  
level surface capable of sustaining the  
combined load.  
Always mount all four mounting arms at  
the appropriate points on the engine.  
All mounting arms must be bolted  
tightly against the engine with at least  
5/8" thread penetration into the engine.  
Never use an impact tool to tighten the  
mounting arm bolts into the engine.  
Tighten all bolts manually.  
Before removing the lock pin to rotate  
the engine, fully support the engine so  
the engine will not uncontrollably rotate  
when the pin is removed.  
Never modify this engine stand.  
Never allow children to play with or  
near the engine stand while in use or in  
storage.  
Avoid moving the engine and stand  
across a floor where a wheel may fall  
into a hole or crack and cause the unit  
to tip and fall.  
1. Attach the post and rear leg to the center  
frame with one M12-1.75 x 60 hex bolt and  
lock washer.  
2. Secure the front leg to the center frame with  
two M10-1.5 x 60 hex bolts, lock washers,  
and nuts.  
3. Insert the flange spindle into the post bore.  
Then insert the rotation handle.  
4. Line up the flange spindle hole with the hole  
in the post and install the lock pin.  
5. Install four mounting arms to the flange with  
four M12-1.75 x 60 hex bolts, lock washers,  
and nuts.  
Model G8722 Assembly  
Note: Refer to Figure 2 for reference.  
1. Attach the front legs to the base with four  
M12-1.75 x 90 hex bolts, lock washers, and  
two nuts.  
Never work under a supported engine.  
Never roll the stand without the lock pin  
installed.  
2. Attach the post to the base with two M12-1.75  
x 90 hex bolts, lock washers, and nuts.  
Periodically inspect the stand bolts,  
framework, wheels, and welds for  
looseness, cracks, or other damage.  
3. Install one M12-1.75 x 25 hex bolt and lock  
washer where each leg secures to the base.  
 

Guardian Technologies Network Card K1148 X 4 98 User Manual
Halo Lighting System Indoor Furnishings H2MDME User Manual
Harbor Freight Tools Sander 47644 User Manual
Havis Shields Work Light CD CL 12 User Manual
Hawking Technology Network Router HWBA54G User Manual
Heath Zenith Door 598 1125 02 User Manual
Heath Zenith Universal Remote 598 1119 05 User Manual
Hotpoint Refrigerator RSA User Manual
HP Hewlett Packard Server DL365 User Manual
HTC PDAs Smartphones PHAR100 User Manual